Picture 1 of 4
Picture 1 of 4
YG-1 V7 Plus-A UGMF68941 4 FL 1/2 x 1/2 x 1-1/4 x 3 Coated End Mill Multi Helix
US $26.60
ApproximatelyS$ 34.40
or Best Offer
Condition:
New
A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details.
Out of Stock90 sold
Postage:
Free UPS Ground.
Located in: Huntington Beach, California, United States
Delivery:
Estimated between Wed, 25 Sep and Mon, 30 Sep to 43230
Returns:
No returns accepted.
Coverage:
Read item description or contact seller for details. See all detailsSee all details on coverage
(Not eligible for eBay purchase protection programmes)
Seller assumes all responsibility for this listing.
eBay item number:285473191801
Item specifics
- Condition
- Brand
- YG-1
- End Type
- Square
- Number Of Flutes
- 4
- End Mill Type
- Square End Mill
- Overall Length
- 3 in
- Material
- Solid Carbide
- MPN
- UGMF68941
- Length Of Cut
- 1-1/4 in
- Mill Diameter
- 1/2 in
- Shank Diameter
- 1/2 in
Item description from the seller
Seller feedback (577)
- a***s (62)- Feedback left by buyer.Past monthVerified purchaseJust as described. Would purchase again!
- c***l (88)- Feedback left by buyer.Past monthVerified purchaseGreat value as described.
- h***e (183)- Feedback left by buyer.Past monthVerified purchaseAll gauge pins were fine. There's a few that measured more than .0002 under
This is a private listing and your identity will not be disclosed to anyone except the seller.